Genelec S30B

System Specifications

Lower cut-off frequency, -3 dB: < 42 Hz
Upper cut-off frequency, -3 dB: > 25 kHz
Free field frequency response tolerance of system ± 3 dB
Maximum short term sine wave acoustic output on axis in   half space, integrated from 100 Hz to 3 kHz @ 1 m > 111 dB SPL
@ 0.5 m > 117 dB SPL
Maximum continuous RMS acoustic input in same conditions with IEC-weighted noise @ 1 m > 104 dB SPL
@ 0.5 m > 110 dB SPL
Maximum peak acoustic output per pair on top of console, speakers @ 1 m from the engineer, with music material > 125 dB
A -20 dBu signal input will produce 87 dB SPL in free field @ 1 m on axis with all controls set at the 'CAL' position. The 'CAL' position is the 0 dB position of all tone controls and the maximum sensitivity position of the input level control. See specification in the Crossover Section.
Input level for maximum short term output +4 dBu
Input sensitivity adjusting range
continuously variable
0...-20 dB (0 dB 'CAL')
Self generated noise level in free field @ 1 m on axis < 10 dB (A weighted)
Harmonic distortion at 90 dB SPL at 1m on axis
f < 200 Hz
f > 200 Hz

< 3 %
< 1 %
Drivers
Bass
Mid
Treble
8" cone (210mm)
3 1/2" cone (80 mm)
3/8" x 2 1/2" ribbon
(9x65 mm) with DCW
Weight 44 lb. (20 kg)
Dimensions
Width
Height
Depth
12 5/8" (320 mm)
19 1/2" (495 mm)
11" (280 mm)

Amplifier
 
Bass amplifier output power at 8 ohm load
continuous
momentary
90 W
110 W
Mid amplifier output power at 8 ohm load
continuous
momentary
25 W
110 W
Treble amplifier output power at 8 ohm load
continuous
momentary
8 W
90 W
Mid and treble channel continuous output power is limited by the electronic overload protection
Slew rate > 20 V /µs
Amplifier system distortion at nominal output
THD
SMPTE-IM
CCIF-IM
DIM100
< 0,1 %
< 0,1 %
< 0,1 %
< 0,1 %
The amplifier system has passed the following tests:  
Dry heat, stock
(72 hours at +55°C, +131°F)
IEC 68-2, Bb
Dry heat, operation
(20 hours at +40ºC, 104ºF)
IEC 68-2-2, Bb
Shock
(1000 shocks at 25 G in each direction)
IEC 68-2-29, Eb
Vibration
(from 10 to 150 Hz at 1 G, 2 hours at each direction)
IEC 68-2-6, Fc
Damp heat, cyclic
(RH 93%, 12 hours at +40°C, +104°F, 12 hours at+25°C, +77°F)
IEC 68-2-30, Db
Cold operation
(20 hours at -10°C, 14°F)
IEC-68-2-1, Ab
Cold, stock
(72 hours at -40°C, -40°F)
IEC 68-2-1, Ab
Temperature changes
(4 cycles from-40ºC to +55ºC and back from -40ºC to +131ºF)
IEC 68-2-14, Nb
Signal to Noise ratio, from shorted system input to channel output, referred to full output
bass
midrange
treble
98 dB
101 dB
97 dB
Mains voltage 110/220/240 VAC
Voltage operation range ± 10 %
Power consumption,
idle
full output
30 VA
220 VA

Crossover
 
Input connector: XLR female pin 2+
pin 3-
Input impedance 10 k balanced
Subsonic filter down 12 dB @20 Hz
re 100 Hz level
Ultrasonic filter down 12 dB @50 kHz
re 10 kHz level
Crossover frequency
bass / midrange
midrange / treble
420 Hz
4  kHz
Crossover acoustical slopes > 18 dB / octave
Tone control operation range in 1 dB steps
bass
middrange
treble
from 0 dB to -6 dB
from 0 dB to -6 dB
from 0 dB to -6 dB
The 0 dB position is the 'CAL' position (switch position number 7)  
Bass roll-off filter in 2 dB steps from -4 dB to +2 dB @ 43 Hz
The 0 dB position is the 'CAL' position (switch position number 3)  

All data subject to change without prior notice
真力中国(北京真力音响有限公司)北京市朝阳区酒仙桥路10号恒通商务园B33一层101   邮编100015   电话:400 700 1978,+86 10 5823 2014